Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Lathe Chucks
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Lathe Chucks
Very well made, can be difficult to turn the jaws around properly at first but only takes a little practice, has an M12x1 thread which was difficult to find a straight arbor for, worked well with a M12x1 motor nut and bolt with the bolt head sheared off though. Has a decent alignment. Very pleased.
Verified purchase: Yes | Condition: New
Got this with hope of using on my home made mini lathe and or my hand drills, all these have a 10mm chuck, so i have an adapter of 12mm diameter thread to fit this mini chuck but not the same screw pitch. I was able to very carefully force the adapter into the mini chuck mounting hole by carefully turning in with patience and much oil. I guess the adapter is a harder metal than of the mini chuck, but i could have used a suitable tap though i suppose, the result is i can now if i wish mount this in my mini lathe or my hand drills. very handy.
Verified purchase: Yes | Condition: New
I was very impressed with the chuck it fitted my mini lathe the quality was good and for model making was just the job
Verified purchase: Yes | Condition: New
I didn't buy this for use in a lathe so can't speak to that particular use. However, it was perfectly fine as a clamp to hold carbon disc whilst drilling.
Verified purchase: Yes | Condition: New
not very happy with quality , it's very dificult to open this jaws ,i have twisted pins trying to open head, its just stuck i will try with wd40 and bigger force moment
Verified purchase: Yes | Condition: New