Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Music Stands
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Music Stands
I've been looking for a two tier stand for a while and ended up getting this one. Like most two tier stands, the top tier is the same width as the bottom layer. The risers attach to the stands edge so not much you can do about that. I ended up getting a shelf from a hardware store and I actually prefer that setup to just a small top tier, it allows me to place multiple devices above my larger keyboard. There are stands where the risers are connected to a pole on the back of the stand but those usually cost 5 times the price of this one. Overall this stand does the job for me and it's definitely a great value at it's price range
Verified purchase: Yes | Condition: New
I purchased this stand because I have two keyboards (obviously) and I hoped to replace my current single stand. My primary is an Alesis Recital Pro 88 Key Hammer-Action piano and I also have an M Audio 49 key MIDI controller. The Alesis is way too big for the lower stand of this product. The stand is sturdy enough to support the weight but the upper "arms" are too short. Fortunately I was able to adapt the upper tier to my original stand. It works flawlessly except that my Alesis's music holder is too tall to be used with the upper keyboard in place. My experience is limited but I'd think this would be fine with two lightweight MIDI controllers but I'd not recommend it for use with an 88-Key dedicated piano. Also the stops on the upper tier are soft rubber which is pretty flexible. They would need to be glued in place if you're planning on heavy duty use of the upper keyboard. Either that or you'd need to fabricate sturdier stops. I'd recommend this product as long as you're aware of its limitations. Otherwise, steer clear.Read full review
Verified purchase: Yes | Condition: New
I love the stand. It was affordable and is sturdy. The only negative I have is the top cross brace for the upper key board is not long enough for the base portion to reach its lowest setting. It will come apart at lowest setting. And the lowest setting is where I'd like to have it. Other than that Perfect. Would have gave it 5 starts if it would reach. One other thing, I'm not sure what the straps on the lower key b support are for or how to use them. Didn't see any instructions on that.
Verified purchase: Yes | Condition: New
I have a moxf8 and a fantom. I had to personally modify this stand so it would work. When stand is set for you to sit down to it, the top keyboard stands stabilizer bar is not long enuff. TOP IS USELESS UNLESS YOU MODIFY IT.
Verified purchase: Yes | Condition: New
Very well constructed, easy to use... I would certainly recommend this product with high praise.
Verified purchase: Yes | Condition: New