I don't normally write reviews, but I thought I should warn others who might be tempted to buy these. The pinout spacings appear to be 0.05 inches, not the standard 0.10 inch. So standard header pins won't work. Standard breadboards won't work either. The holes in the board where the pins would go are too small to accept standard 22 gauge wires. I had to go out and buy 26 gauge in an attempt to make these boards work. Then I had to solder some 22 gauge wires to the 26 gages I could plug the radio board into a breadboard. So 16 solder joints just to get electrical connections. And since you need two radios to communicate with each other, you need to make 32 joints. So you're looking at a couple of hours of tedious soldering The pinouts are not marked in any way. Good practice is obviously to mark the pins on the board.Read full review
Verified purchase: Yes | Condition: New
Verified purchase: Yes | Condition: New
Verified purchase: Yes | Condition: New
Good
Verified purchase: Yes | Condition: New
All good
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other Consumer Electronics
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Consumer Electronics