Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Shotgun Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Shotgun Parts
First off I was sceptical because there is hardly any options for my Remington 887 Nitro Mag tactical, but this purchase was super smooth from beginning to end. Assembly of the stock is easy enough for a 1st grader to figure out even if it didnt have instructions. Installation of the stock assembly onto the shotgun was just as easy. All necessary hardware was included even for my oddball shotgun. Once the stock is on the shotgun it felt amazing. Wonderful grip, quicker target aquisition, the Scorpion recoil pad absorbs even 3&1/2" rounds easily whole new gun all over again, I love it!
Verified purchase: Yes | Condition: New
I bought this thinking it would make the stock significantly shorter than the original stock that came with the shotgun. It only shortened it by maybe 1". That was disappointing. The instructions are somewhat vague. Pictures are grey and small. I had to take a picture on from my phone and then enlarge them. Parts were not labeled. If you don't know what you're doing, you'll struggle a little bit. My adapter did not correctly fit up against my shotgun. It left a 1/16" or so gap. (See Pic) When I tightened the bolt, the gap is still there. I tightened it as much as I could and it jammed up the slide and wouldn't allow me to rack it. I had to loosen it till the slide worked. Not sure how long it will be till it becomes loose and I have to take it apart to tighten it again. The screw that came with it to fasten the collapsible stock to the back of the new pistol grip did not go in all of the way. I actually had to go to Ace Hardware and buy another screw and square nut. Either it's bad machining or bad quality control or both. I finally got it together. Now that I know what I'm doing and how it goes, it should only take 30 minutes or so if that. Disappointing product just because of the fit. Read full review
Verified purchase: Yes | Condition: New
Anyone can install this, even if you have never disassembled your shotgun. Its not rocket science. Its a gun.
Verified purchase: Yes | Condition: New
Very pleased with this much needed ergonomic upgrade to my VRPA40. Easier handling and slightly shorter length of pull on closest adjustment, which I preferred. Use the TriStar Raptor/Cobra adapter for a perfect fit on the VRPA40. Several other adapters are included for other brands.
Verified purchase: Yes | Condition: New
Easy to attach. Fits my cheapo Stevens 320 20 guage like a dream. Good gun great stock. With this adjustable stock my wife and I can both use it and it looks way better.
Verified purchase: Yes | Condition: New