Compared to Bestequip 8x16..., almost same weight but far better!, Nearly same size head but larger head components "spindle and gears". Gears have tooth count marked on them, very little play, very quiet running, easy cleanup on gearbox, less mistakes during manufacturing, all parts of rest work smoothly, just shy of 30" center to center, extra tapped holes in rest "assumed" for milling attachments located in correct spot for travel both ways. Few cuts on spindle face took .05mm run out to zero. Only complaint is Chuck had .007" run out just off jaws tested w Brown & Sharp center. Ordered new 5" certified 3 jaw and for the through hole a 6" 4 jaw independent as well. (10mm) 3/8" tooling works good with axa Quick change, not sure about parting tool height so plans are for carbide parting tool holder. Will definitely cover all of my hobbies from gunsmith to automotive street rod.Read full review
Verified purchase: Yes | Condition: New
Surfaces were covered with a rust inhibitor to prevent rusting, tools included, fully assembled, runs great.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Metalworking Lathes
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Metalworking Lathes