Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other RC Parts & Accs
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other RC Parts & Accs
Not gonna lie took me about 8 hours to get this thing operating how it should. That being said, It works really well. No instructions. Youtube is your best friend here. Had to reverse the lower motor arm(3 screws) to make it so i could use it with my hero3+ and not have to take it out every time just to get access to the sdcard and av/charging port. Balancing the camera is KEY to good operation. Balance it, wiggle it, see if it falls back close to center. The connector for the pitch cable on mine was the top left pin on the connector. It weighs twice as much as my zenmuse h32d did so expect slightly lower flight times. Without proper balance the gimbal will move when you turn and skew your horizon. Needed tape as well to keep it in place as there isn't really anything there to keep the camera from sliding on the platform it sits on no matter how tight you get the strap. Have not been able to find any firmware upgrades that work with this board. Guess I don't really need them. Its nowhere as good as my old gimbal but for the price and performance it will stay on my bird till it dies. So, if you purchase, be ready to sit down for a while with it and be ready to do a lot of youtube watching and trial and error before you get it right. On a good note, by the time you get it right you will be an expert with it and its software. Take breaks cause it can be a frustrating install.Read full review
Verified purchase: Yes | Condition: New
Pretty well built considering the price. Not real pretty but it works extremely well. No instructions but You Tube has lots of videos on how to install. Pitch control wire goes on bottom left on gimbal and bottom far left on Naza. I had to do "trial and error" to get it right. If attached to center pins on Naza, alarms will go off or gimbal will flip around. Adjusting pitch using software for Phantom 1 had minimal effect. Camera points slightly upward and I'm still trying to figure out how to correct that. Recommend purchasing the pitch lever made by DJI for the transmitter. Works well and be sure and heed all precautions. You will also need to purchase taller landing gear. GoPro 3 mounts upside down and I suggest turning on and mounting camera before powering up your quad. Tested gimbal when it was very windy and camera was rock solid. Very impressive performance. You can't go wrong for the price. Beats shelling out over 1000 bucks for a Phantom 4. I recommend this product if you're like me and want to breath new life into your Phantom 1.Read full review
Verified purchase: Yes | Condition: New
The Gimbal works fine on my UPair One, need to rewire the Gimbal to the controller board and it tricky, UPair One does not make it easy to replace a broken OEM Gimbal to this product. But good thing it can be done, and really needs to re calibrated using software, But it works like it should, flawlessly it does !!
Verified purchase: Yes | Condition: New
It's a good gimbal i had to replace the board in it and now it's working great
Verified purchase: Yes | Condition: New
No problems with this, I placed a different camera on here, takes a little adjustment to get it right. Once you have it right it is flawless. Not a high dollar gimbal, but performs like one!
Verified purchase: Yes | Condition: New