 |
I have used this (and other) stay brite products for many years and have always been satisfied with the results. Most of my applications involve modeling such as model railroading where brass work may require the extra strength of a silver bearing solder. Here, a little goes a long way. I always use a small artists brush to apply the flux.
Verified purchase: Yes | Condition: New
It worked really well for soldering 1/4” and 3/16” stainless rod. I suspect that it will also work as well for thicker metal, but you might need to use an acetylene/ oxygen torch. I used a hand held torch with a propane bottle and later a yellow mapp tank. Both worked extremely well.
Verified purchase: Yes | Condition: New
Have used this solder for years, works on nickel silver silver brass bronze stainless steel and mild steel., it is around 300 degree solder.
Verified purchase: Yes | Condition: New
This a very good solder for extra strength. It has a higher melt temp.so it takes a heaver iron than electrical solder. The flux is an acid flux and will cause rust if it is not cleaned.
Verified purchase: Yes | Condition: New
Excellent for high strength soldering, used it for many years! The best
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Paints
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Paints
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
