Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in 3D Printers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on 3D Printers
This is a great printer, especially for the money spent . It takes minimal time to assemble considering most of it is done when you receive it. I did have to make some adjustment with the rollers, but that was expected. Everything was packaged well. Wiring was a breeze , all the wires are labeled so there is no confusion. After leveling the bed I was printing in under 30 minutes. Print quality with no adjustments was surprisingly good, and after a few tweaks it prints like a printer that should cost 3x the money. I’m extremely please with this printer so far and would most certainly purchase again!!!
Verified purchase: Yes | Condition: New
After hours of searching the internet reviews I settled on this relatively easy to assemble kit. I had little knowledge of 3d printers up to this point. I should caution you that 3d printers are not idiot proof and require patience tweaking settings to get the proper results. Much of the difficulty is the fact that some items are much more difficult to print do to virtually anything can be attempted, and some items may be near impossible, requiring complex supports, while others are quite easy. It won't take long to get the picture after a few attempts. They are not an inkjet you fill with paper and press print! However if your expectations are reasonable, you will be pleasantly surprised with this unit. The toughest part of the assembly was being sure the wires were connected correctly, other than that very straight forward. It's well built & I most likely will buy another Geeetech , perhaps even an A30 this time. PS the grandkids are totally amazed!Read full review
Verified purchase: Yes | Condition: New
This machine is quality, It runs fairly quiet. I haven't tuned it yet, but it looks really close right out of the box. The assembly instructions could be improved, although it doesn't take an engineer to put it together One thing, attach the display flat cable before mounting it. And on zeroing, I did graze the clip holding the glass on. I just moved it back about 15 mm and it seems to be ok. All in all, I would buy another one of these to set right beside this one if I had the room.
Verified purchase: Yes | Condition: New
This is the printer everyone should buy first. It is easy to assemble. Easy to set up and easy to understand. It is well made. The frame is aluminum and rigid. The steppers seem to be of quality, but only time will tell. Mine had a broken limit switch on the Z axis. I located one locally and soldered it to the base board for mounting. About $0.35.......(3Pin SPDT Limit Micro Switch Long Hinge Lever) Other than that, it is a good starter unit to learn on or to do a limited run .
Verified purchase: Yes | Condition: New
Excellent printer for the beginner before going to the big bucks 3D printers.
Verified purchase: Yes | Condition: New