CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Coax. Cables & Connectors
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Coax. Cables & Connectors
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
Good ... got here fast
Verified purchase: Yes | Condition: New
2nd time ordering thes connectors they halve the wrong threads on them wont mate with a u.s.a. made connector they bind up before ther all the way down and tight unable to use this copy of a u.s.a. connector with the wrong thread you can tell the bad item I got by the threads don't go down the shaft to the flange they stop 11/64 up from the flange. the so 259 is not metric. good luck ther is a us dealer ham that sells a good so259 connector I cant tell you
Verified purchase: Yes | Condition: New
The connector is a second class where the centre party is so tight that the centre tap from the male jack nearly cannot be pressed into the socket. Next is that the tread is not the right one, it does not match the outer ring at the male plug! It is NOT recommendable to buy this "non-standard" flange socket, it is directly vast of money! Apparently I had to mark a star in order to submit however no starts should be the right marking.
Verified purchase: No
Its ok, but isolation material isn't ptfe.. just color of isolator is like ptfe.. :)
Verified purchase: Yes | Condition: New
The insulation around the center pin is foam plastic and it shrinks if you overheat it when soldering the center pin. Then it turns freely when you screw on the cable, which twists off the wire you soldered on there. The center pin is hard to solder because the metal it's made of doesn't take solder easily.
Verified purchase: Yes | Condition: New
